An easy option to properly finish a carpet installation at a door entrance or transition.
Ways to install carpet with z bar.
Some are held in position by.
Mount tack strips to sub floor.
Start in the corner of the room furthest from the door way and work your way toward the door.
How to fold carpet when laying next to ceramic tile flooring 1.
Once the padding is in place staple it down every 2 feet and duct tape the seams together.
Measure the width of the join between the ceramic flooring tiles and carpet.
Measure the opening of the doorway or entryway where you will be installing the z bar.
Simply put this transition bar has the form of the z letter to ensure that the carpet s edge is tucked under the tile.
The z bar needs to be able to lay.
Learn how to use a z bar in this free video on carpet cleaning and installation.
Cut the z bar to this.
Next place the carpet over the z bar and the tack strip and use the carpet kicker to stretch the carpet.
Cut the padding underneath the carpet back to the point of where the z bar will start.
Fold the carpet over on the edge and using your knee kicker stretch the carpet to the z bar.
Once stretched trim the carpet 1 inch past the edge of the tile.
Use the carpet cutter tool to cut the carpet a few inches longer and wider than the length and width of the room and then roll the carpet inward for easier installation.
Next unroll the carpet padding from one side of the room to the other and slice it off with a box cutter.
With this method you are going to tuck the edge of the carpet into the z bar and then fold it over itself.
When you do this you are going to be able to run the carpet directly up to the edge of the tile.
Cut the z bar to fit using a hacksaw.
How to install a z bar carpet strip step 1.
A special tool called a z bar enables you to install lengths of carpet in doorways so that they fit perfectly.
To install carpet start by nailing the tack strips to the floor using 2 nails for each strip.
That way the carpet is already tucked in and you re just adding an extra level of security.
The z bar will then screw down into the sub floor and hold the carpet in place.
Pull the padding only and place over the installed tack strip trim the padding with the edge of the tack strip keeping your hand on the angle away from the nails.
Bring the carpet up to the transition point and measure 1 extra inch.
Keep in mind though that this option will work best if you install the carpet before the tile floor.
